Category Archives: Repair Station Tools

New VTOS Tools support for NXP QorIQ T1xxx

VTOS ToolsVTOS DDR and VTOS Scan Plus were updated to support NXP QorIQ T1xxx family of processors. Use the the tools for DDR3/4 tuning and validation. Create tests and commands for working with GPIO, I2C, SPI, UART, Bluetooth, Ethernet PHY, and SD/MMC/SDIO devices. Read more

Posted in DDR Calibration and Validation, Design, Hardware Interface Testing, Repair Station Tools, Test Automation | Leave a comment

Creating Custom Tests with Kozio Scripting

VTOS ToolsWe added a new feature to make it easier to add custom tests and custom commands to your test configuration. Read more

Posted in DDR Calibration and Validation, Hardware Interface Testing, In-System Device Programming, Repair Station Tools, Test Automation | Leave a comment

VTOS Scan™ Plus for SD/MMC/SDIO and Ethernet PHY Testing

blog-banner-vtos-scan Introducing VTOS Scan Plus for validating SD, MMC, SDIO, and Ethernet PHYs. VTOS Scan Plus validates communications over the bus interface and communications with devices. It also verifies device identification details and performs checksum verification on device content. Read more

Posted in Hardware Interface Testing, Repair Station Tools | Leave a comment

Customer Story: Success Isolating Board Issues for Repair Station

kozio-customer-storyThe customer needed an easy-to-use solution that would isolate failing components on bad i.MX6 (ARM® Cortex®-A9) boards. Kozio provided and demoed a DDR validation tool and a hardware test tool that found eMMC issues. Read more

Posted in DDR Calibration and Validation, Hardware Interface Testing, Repair Station Tools | Leave a comment